Cadillac, Chevy, GMC, Buick, Hummer H2 Keyless Keyfob Remote Programming 2007 and up.wmv



Visit us at http://www.carandtruckremotes.com/

Remote programming for most trucks made before 2007. Programming method 1 (for trucks listed below)

2004 2005 2006 2007 Buick Rainier keyfob

2002 2003 2004 2005 2006 Cadillac Escalade keyless remote control

2000 2001 2002 Chevy Astro remote

2002 2003 2004 2005 2006 Chevy Avalanche remote keyless entry opener

1998 1999 2000 2001 2002 2003 2004 2005 Chevrolet Blazer keyless entry remotes

1999 2000 2001 2002 2003 2004 2005 2006 Chevy Silverado remotes (including 2007 Silverado Classic model)

2000 2001 2002 2003 2004 2005 2006 Chevrolet Suburban SUV remotes

1998 1999 2000 2001 2002 2003 2004 Chevy S10 pickup truck remote key fob

2000 2001 2002 2003 2004 2005 2006 Chevrolet Tahoe remote controls

2002 2003 2004 2005 2006 2007 2008 2009 Chevy Trailblazer remotes control

2002 2003 2004 2005 2006 2007 2008 2009 GMC Envoy SUV remote keyless system programming

2003 2004 2005 2006 2007 2008 Isuzu Ascender remote door opener

1998 1999 2000 2001 2002 2003 2004 GMC Jimmy truck remote door opener

2000 2001 2002 2003 2004 2005 GMC Safari van remotes

1999 2000 2001 2002 2003 2004 2005 2006 GMC Sierra remote key fob (including 2007 GMC Sierra Classic remote)

1998 1999 2000 2001 2002 2003 2004 GMC Sonoma pickup truck remote system

2003 2004 2005 2006 2007 Hummer H2 remote controls

2002 2003 2004 Oldsmobile Bravada SUV remote

Programming instructions

IMPORTANT: Before entering programming mode, have in possession all of the GM remote transmitters you will be using on the vehicle. Once you program the transmitter, all previous codes will be erased from the memory if not reprogrammed during the same programming procedure. The other transmitters will not be functional until you program the transmitters again with new remote.

Switch ignition ON.

Repeatedly press vehicle information button (it is usually located on the right or left from the steering column depending on year make and model) until PRESS TO RELEARN REMOTE KEY is displayed.

Press set/reset button until REMOTE KEY LEARNING ACTIVE is displayed.

Programming mode activated, proceed as follows:

Press and hold LOCK and UNLOCK remote buttons on first remote transmitter simultaneously for 15 seconds.

Wait for acoustic signal (indicates correct programming).

Repeat above procedure to program remaining remote transmitters.

Switch ignition OFF to exit programming mode.

Remote transmitters can also be programmed using diagnostic equipment.

NOTE: A maximum of 8 remote transmitters can be programmed.

Programming method 2 (for vehicles listed below). Most of the vehicles below offer simple remote controls with just lock and unlock feature, and some offer a remote engine starters, power lift gate and other options.

2008 2009 2010 Buick Enclave keyless entry remotes

2006 2007 2008 2009 2010 Buick Lucerne keyless entry remote

2007 2008 2009 2010 Cadillac Escalade keyless entry remote controls

2007 2008 2009 2010 Chevy Avalanche keyless remotes

2007 2008 2009 2010 Chevrolet Equinox remote control transmitters

2007 2008 2009 2010 Chevrolet Monte Carlo transmitter controls

2006 and up Chevy Impala remote door transmitters

2007 2008 2009 2010 Chevy Silverado truck remote control

2007 2008 2009 2010 Chevrolet Suburban remotes

2007 2008 2009 2010 Chevy Tahoe keyless entry remotes

2007 2008 2009 2010 Chevrolet Traverse keyless entry remote

2007 2008 2009 2010 GMC Acadia remote controls

2007 2008 2009 2010 GMC Sierra truck remote door openers and remote start

2007 2008 2009 2010 GMC Yukon remote with and without remote engine start

2008 2009 Hummer H2 keyless entry remotes

2007 2009 Pontiac Torrent remote entry system control


Post time: Apr-21-2017

INQUIRY DETAILS *

INQUIRY NOW
  • captcha